Step 1: Before opening and disassembling the fixture, make sure power has been turned off at the main circuit breaker and remove the bulbs from the fixture. Step 2: Open your fixture and examine the wiring. You will see either Electronie Ballast or Magnetic Ballast in your fixture. The wiring diagram for a typical fluorescent fixture using single-pin, stationary/plunger-type sockets is shown below step 3. Although configurations may vary, the basic concept is the same. If you have a different wiring fixture, please contact us to [email protected] . Step 3: Remove or bypass the ballast indicated in the diagram below: cut or disconnect the wires in the locations indicated. Try to leave enough wire to allow rewiring of the sockets to the line and neutral as shown in the diagram in step 4.
Electronic Ballast Type
Magnetic Ballast Type
Step 4: Connect the Live wire to one side (the single-wire plunger sockets) and connect the Neutral wire to other side (the double-wire stationary sockets) as shown below. Make sure all wire connections are wire nutted and wrapped with electrical tape, and make sure the fixture is properly grounded before reassembling the fixture.
Electronic Ballast Type
Step 5: Install your new LED tubes in the fixture.
JESLED, devoted to LED lights manufacturing since 2009, focused on providing environmentally friendly LED products and offer the best price-quality relation possible. All of our products comply with international quality standards and are greatly appreciated in a variety of different markets throughout the world. Furthermore we attach great importance to our customer experience and value every constructive feedback from them to improve our products and services. Today, JESLED offers a wide variety of cost-effective, high quality led products for every facet of life. We committed to providing each customer with the highest standard of customer service. "CUSTOMER FIRST, QUALITY SERVICE" " SAVE ENERGY, MAKE YOUR LIFE BRIGHTER" JESLED LIGHTING
